PLA 3D printer filament Material Characteristics: 1. PRILINE PLA （Polylactic Acid） is one of the most popular materials for 3D printing. Our PLA filament has a relatively low melting temperature, low warp properties and is biodegradable. It’s suitable for home printers, hobbyists, and schools. 2. PLA filament has a low shrinkage rate and it is very rigid with minimal flex. This material can print extremely high resolution models and is perfect for a wide range of uses. 3. PLA filament has a huge range of vibrant colors and opacity for that perfect look whether it is artistic or utilitarian. PLA can be printed without the use of a heat bed, and can stick to glass or a PCB plate with a binder such as hairspray or white glue for a curl free print. Product Details: 1. 1 KG (approximately 2.20 lbs) Spool 2. 1.75mm Filament Diameter (Dimensional Accuracy +/- 0.03mm) 3. Recommended Printing Temp/Nozzle Temperature: 180-220°C(356-428°F) - Base Plate Temperature: 0-50°C(32-122°F) 4. Spool Diameter: 7.87" - Spool Width: 2.83" - Spool Hub Hole Diameter: 2.20" 5. High Compatible With Your 3D Printer: For common all 1.75 mm specification 3D printers such as Ultimaker, Zortrax, Lulzbot, BCN3D , FlashForge, Makergear, MakerBot, Prusa, CEL, Robo. PRILINE 3D Printer Filament Storage Tips: 1. Since PLA material is made from biodegradable sources, it is susceptible to moisture. We recommended storing filament in a sealed plastic bag or box after each print. 2. If the filament gets damp, you can bake it in an oven with 50°C(122°F) for about an hour to restore its dryness. Friendly Reminder(After Use): Be sure to insert the free end of the filament into the hole to avoid the filament being tangled for next time use.
J**.
Didn't arrive
May well be a good product, i will never know
N**0
Pretty good filament...
This was the second roll of PriLine PLA Filament I've tried, the other was a plain grey. I've found the quality of prints are pretty good, feed rate is consistent, finish superb and definition of detail good also. In the pictures I've attached there is one of an 'Owl' I scaled up (the one on the right) the smaller one was printed months ago at normal size using Ziro filament. The other picture is a statue of 'Vampirella' (a comic book character, again scaled up to 200%. The Vampirella is particulary impressive as the cloak printed without any supports, yet as you can see it is almost perfect. All prints were produced on a standard Creality Ender 3 with no mods applied. I will almost certainly be buying this filament again.
Trustpilot
2 days ago
1 week ago
