Greenf BxuxJar Car Dent Puller Repair Tool - Car Dent Repair Kit Sheet Hail Pit Sagging Repair Tools Plastic Suction Cup Universal

Dent puller operation skills 1. The ket should be stuck to the bottom of the concave, not to the concave wall, otherwise it is easy to come unglued.Puller kets are plastic kets with no suction. 2. The ket can not tilt pull, otherwise it is easy to come unglued. 3. If the dent is large, do not stick the ket directly in the middle of the dent, but from the concave edge to the middle of the operation. Dent puller adhesive skills 1. Power on the glue and heat the glue stick fully. After melting, drop the glue on the ket and stick to the car body quickly, because the solidification time of the glue is very fast. 2. Blow the sheet metal with a hair dryer to keep the temperature of the sheet metal, immediately stick the ket coated with glue, and wait for about five minutes to operate. Description It is made of aluminium alloy for strong strength and long durability body repair dent removal tools. Used as a adapter for slide hammer or pulling tap for easy catching and pulling car dent repair tool. a necessary component for dent repair, direct replacement for the broken one. Easy installation, the thread size is M10 for better application auto body tools. 100 percentage Brand new and quality auto dent remover. Material: Aluminum Alloy Type: M10 Warm Tips: May not work well with dents that are not mostly flat.Package Included 1pcs x Slide Hammer 18pcs x Blue Glue Tabs

• How to Use the Dent Repair Tools Clean the dent with a clean wet cloth; the glue stick into the glue ,pull the trigger to let the glue stick into the glue , connect the power source and preheat for 5 minutes(Note: Glue not included.You need to buy the Hot Glue by yourself).
• Use a proper drawing ket. Large dent requires a large drawing ket. (Note: The larger the drawing ket is, the larger the drawing force is).
• Pull the trigger and apply the drawing ket with extruded glue (The 4 holes of ket should be applied with hot melt glue);Fast place the drawing ket with hot melt glue at the center of dent, press lightly until the glue cures and adheres (Let the glue cool for about 8 minutes. The cooling time should be less than 10 minutes and should be shorter slightly in winter).
• Align the T-shaped repairer and press the drawing ket with hot melt glue, pull the sliding rod backwards to pull up the dent;(Note: :The 18 kets are all made of hard plastic and have no suction itself. It is necessary to melt the glue stick with a hot-melt glue and apply it to the kets for use).
• Check with a Line board. If dent still exists, knock it slightly with a flattening hammer or pen; Clean the repaired place with a clean wet cloth.