Zmoon LED Light Bar Wiring Harness, Off Road On Off 12V 40A with 3 Fuse Power Switch Relay for LED Work Lights Driving Fog Light

There wasn't enough wire to reach my LED lights do I had to splice some on. Other than that, decent product. Install was straight forward.

Super easy to install! I enjoyed the simplicity of this item almost no tools were required when installing the harness! I highly recommend purchasing the wiring harness for led bar. Feel free to check out my channelYouTube: GoGetterGarage

Lo utilice para los faros de mi ATV, muy bueno

Exactly what wanted , i bought it with the 12 inch light bar and it works good , the connections and the switch looks solid .

It was a perfect match, and simple install. The wire harness was plug and play to our ZMOON LED lights. I would recommend this harness for any spot light or light bar install.

Wiring is heavy enough and decent quality but the switch broke not even 2 hours after installing it.

worked as expected, Plenty of length to run and easy for DIY folks like me !

Wouldn't want to hook up lights without this.

Good but overpriced

Bon filage pour des lumières del de tracteur et facile a installer .

The whole kit is nice in that it has everything needed to set up a light bar.► Cabling - is 16 gauge wires for those carrying current (battery to relay - relay to light bar) and 20 gauge for control cables.► Each of the wires have standard crimped on connectors. I prefer soldered as they don't come lose or corrode over time like crimped connections especially when used on off-road vehicles.► The included relay is rated at 40Amp's which is sufficient for most LED light bars but its a proprietary item. You won't find this at most automotive parts stores.► It has nice tactile feedback and the teardrop design is easy to mount► With red and green LED's I can make sure that the lights are turned on or off even if there is a break in the connections, it allows for troubleshooting which I've needed on more than on occasion over the years.♦ These LED's are bright enough that they can be seen unless it's midday under bright sunshine.On the downside:► The switch could be improved. Using double-sided tape is a cheap way to do things. There should be a mechanical way to mount it. A few miles of off-road travel will loosen this off in no time.

The Zmoon LED Light Bar Harness isn’t the highest quality, however it is configured for an easy/straight forward install. There are 8 available connections/wires to hook up. Two light bars, main power and ground, and power and ground for the switch. If you are hooking up only one or two accessories that can operate on the same switch, then this harness is adequate. However if you’re like me and want all the different lighting accessories, you’ll want more switches. The main power is intended to be connected to the battery of your vehicle. The switch is intended to be connected to an ignition source. This way you if you turn the vehicle off the relay will not stay latched and drain your battery. Overall a decent wiring harness that comes with everything you need. The relay is sealed and there are pretty clear directions.

The harness itself is pretty decent. The wires are thick, and have a decent coating on them. Everything is neat and organized. I don't like the switch, and would recommend to everyone to buy another switch to replace the one that comes on this harness. It feels cheap, and I'm not sure how long it would last to be honest. I knew this going in, and that wouldn't deter me from buying this harness in the future. I'm particular about my switches anyway and would want it to be custom.